SmartLink by Weathermatic   |    Catalogs    |    Support

Weathermatic
Weatherematic
CATALOGS   |   SUPPORT SmartLink by Weathermatic
Weathermatic

D50 Series Nozzle Installation Guide

Print

STEP 1: Remove Drive Assembly

STEP 2: Install New Nozzle

  1. Remove screws (2) on top of nozzle cap.
  2. Pull off nozzle cap.
  3. Snap in correct nozzle. (see Performance Chart)
  4. To remove nozzle, pull out using snap ring tool or screwdriver.

STEP 3: Install Drive Assembly

  1. Reinstall nozzle cap with screws (2).
  2. Install new snap ring under cap.
  3. Place assembly in body.
  4. Push assembly until flush.
  5. Using tool push down in snap ring slots (2) until it clicks in.

🔗 Performance Data

Table of Contents
Go to Top