SmartLink by Weathermatic   |    Catalogs    |    Support

CATALOGS   |   SUPPORT SmartLink by Weathermatic

DI865T Series Installation Guide


STEP 1: Remove Drive Assembly

STEP 2: Install New Nozzle

  1. Remove screws (2) on top of nozzle cap.
  2. Pull off nozzle cap.
  3. Snap in correct nozzle. (see Performance Chart)
  4. To remove nozzle, pull out using snap ring tool or screwdriver.

STEP 3: Install New Conversion Drive Assembly

  1. Place new assembly in body.
  2. Install new snap ring.
  3. Reinstall cap with screws (2).

Adjustable Part Circle Operation

  1. Rotor must be OFF.
  2. Rotate EASY ARC.
  3. Using a small screw driver or pointed object, move right and left tabs on each side of the Nozzle Marker. Example 180˚
  4. Install EASY ARC cap.

NOTE: Make sure nozzle faces area to be irrigated.

🔗 Performance Data

Table of Contents
Go to Top