How Can We Help?
Search for answers or go to Knowledge Base Home
General Info
Controllers
- PROBLEM: Controller won't allow to SMART and/or no antenna icon on display
- PROBLEM: No Display
- PROBLEM: FAULT icon on display
- PROBLEM: Display shows zone is running but no sprinklers are operating
- PROBLEM: Controller keeps repeating a watering cycle
- PROBLEM: Display shows 0 ZONES
- PROBLEM: Controller does not turn on zone when expected
- PROBLEM: Controller does not turn on zone when expected
- PROBLEM: Controller won't allow to SMART and/or no antenna icon on display
- PROBLEM: No Display
- PROBLEM: FAULT icon on display
- PROBLEM: Display shows zone is running but no sprinklers are operating
- PROBLEM: Controller keeps repeating a watering cycle
- PROBLEM: Display shows 0 ZONES
SmartLink
Golf Products
- DI6734T Series Performance Data
- DI6734 Series Installation Guide
- DI6735T Series Performance Data
- DI6735T Series Installation Guide
- DI6754T & DI694T Series Performance Data
- DI6754T & DI694T Series Installation Guide
- DI6785T Series Performance Data
- DI6785T Series Installation Guide
- DI834T Series Performance Data
- DI834T Installation Guide
- DI865T Series Performance Data
- DI865T Series Installation Guide
- Toro Internal Assembly Nozzle Chart
Other Products
- EM-7 Installation & Service Manual
- RM Series Service Manual
- RM Series Installation & Operating Instructions
- SSR10 Service Instructions
- SSR10 Owner's Manual
- Mark Series Wiring Diagram
- Mark Six and Mark Eight Operation Manual
- Mark A & Mark 200 Series Operating Manual
- 954 Charger Module Installation Instructions
- LM & LMC Operating Manual
- Weathermate Operating Manual (Espanol)
- Weathermate Operating Manual
- Articles coming soon
FAULT: ZONE XX SHORT, MV1 SHORT, MV2 SHORT
Print
OUTPUT SHORT CIRCUIT: A load placed on any output that results in a current draw exceeding the skip current setting will result in a fault after the output is turned on. The output will be skipped until the next watering program attempts to use it. If the MV/P output is shorted, all zones using it will effectively be skipped. The fault indication can be manually cleared or will be automatically cleared if the short condition goes away and the output turns on successfully.
Table of Contents