How Can We Help?
Search for answers or go to Knowledge Base Home
General Info
Controllers
- PROBLEM: Controller won't allow to SMART and/or no antenna icon on display
- PROBLEM: No Display
- PROBLEM: FAULT icon on display
- PROBLEM: Display shows zone is running but no sprinklers are operating
- PROBLEM: Controller keeps repeating a watering cycle
- PROBLEM: Display shows 0 ZONES
- PROBLEM: Controller does not turn on zone when expected
- PROBLEM: Controller does not turn on zone when expected
- PROBLEM: Controller won't allow to SMART and/or no antenna icon on display
- PROBLEM: No Display
- PROBLEM: FAULT icon on display
- PROBLEM: Display shows zone is running but no sprinklers are operating
- PROBLEM: Controller keeps repeating a watering cycle
- PROBLEM: Display shows 0 ZONES
SmartLink
Golf Products
- DI6734T Series Performance Data
- DI6734 Series Installation Guide
- DI6735T Series Performance Data
- DI6735T Series Installation Guide
- DI6754T & DI694T Series Performance Data
- DI6754T & DI694T Series Installation Guide
- DI6785T Series Performance Data
- DI6785T Series Installation Guide
- DI834T Series Performance Data
- DI834T Installation Guide
- DI865T Series Performance Data
- DI865T Series Installation Guide
- Toro Internal Assembly Nozzle Chart
Other Products
- EM-7 Installation & Service Manual
- RM Series Service Manual
- RM Series Installation & Operating Instructions
- SSR10 Service Instructions
- SSR10 Owner's Manual
- Mark Series Wiring Diagram
- Mark Six and Mark Eight Operation Manual
- Mark A & Mark 200 Series Operating Manual
- 954 Charger Module Installation Instructions
- LM & LMC Operating Manual
- Weathermate Operating Manual (Espanol)
- Weathermate Operating Manual
- Articles coming soon
PROBLEM: No Display in Controller
Print
CAUSES
Open fuses for inverter and battery
No display on remote meter and no battery charge
No power from inverter
SOLUTION
Fuse for inverter is 1.5A Fuse for battery is 15A.
If fuses are good, check battery voltage. This controller is designed to shut down when battery voltage drops below 11v to protect batteries.
Using your voltmeter, check for incoming power to the inverter as DC power; check for output power from the inverter as A/C .
Table of Contents