Search for answers or go to Knowledge Base Home
General Info
Controllers
- PROBLEM: Controller won't allow to SMART and/or no antenna icon on display
- PROBLEM: No Display
- PROBLEM: FAULT icon on display
- PROBLEM: Display shows zone is running but no sprinklers are operating
- PROBLEM: Controller keeps repeating a watering cycle
- PROBLEM: Display shows 0 ZONES
- PROBLEM: Controller does not turn on zone when expected
- PROBLEM: Controller does not turn on zone when expected
- PROBLEM: Controller won't allow to SMART and/or no antenna icon on display
- PROBLEM: No Display
- PROBLEM: FAULT icon on display
- PROBLEM: Display shows zone is running but no sprinklers are operating
- PROBLEM: Controller keeps repeating a watering cycle
- PROBLEM: Display shows 0 ZONES
SmartLink
Golf Products
- DI6734T Series Performance Data
- DI6734 Series Installation Guide
- DI6735T Series Performance Data
- DI6735T Series Installation Guide
- DI6754T & DI694T Series Performance Data
- DI6754T & DI694T Series Installation Guide
- DI6785T Series Performance Data
- DI6785T Series Installation Guide
- DI834T Series Performance Data
- DI834T Installation Guide
- DI865T Series Performance Data
- DI865T Series Installation Guide
- Toro Internal Assembly Nozzle Chart
Other Products
- EM-7 Installation & Service Manual
- RM Series Service Manual
- RM Series Installation & Operating Instructions
- SSR10 Service Instructions
- SSR10 Owner's Manual
- Mark Series Wiring Diagram
- Mark Six and Mark Eight Operation Manual
- Mark A & Mark 200 Series Operating Manual
- 954 Charger Module Installation Instructions
- LM & LMC Operating Manual
- Weathermate Operating Manual (Espanol)
- Weathermate Operating Manual
- Articles coming soon
Quick Start: ProLine Controller
Use PGM to select program A, B, C, or D.
Use NEXT and BACK buttons to select options and scroll between zones.
2. Set daily start times (AM/PM) for Programs (A, B, C, D) in use. Normally, one start time is sufficient. The start time is for the Program and not each zone. The Program will run all zones in consecutive order for each start. (more >)
3. Set zone run times (1 min to 9 hours 55 minutes) for Programs (A, B, C, D) in use. (more >)
4. Set watering days by selecting days of week or interval (1 to 30 days) or odd or even days for Programs (A, B, C, D) in use. (more >)
5. Set omit times, days, and dates to accommodate watering blackout periods (optional). (more >)
6. Set monthly % by month for Programs A, B, C, D (optional). (more >)
7. Return dial to RUN.
Manual Zone (more >)
Turn dial to MANUAL ZONE. Use NEXT button to select zone to run. Use UP and DOWN buttons to select zone run time (1 min to 9 hours 55 minutes). Return dial to RUN to start.
Turn dial to MANUAL TEST. Use UP and DOWN buttons to enter run time (10 seconds to 10 minutes) for all zones with assigned run time. Return dial to RUN to start.