-
General Info
-
Controllers
-
-
-
- PROBLEM: Controller won't allow to SMART and/or no antenna icon on display
- PROBLEM: No Display
- PROBLEM: FAULT icon on display
- PROBLEM: Display shows zone is running but no sprinklers are operating
- PROBLEM: Controller keeps repeating a watering cycle
- PROBLEM: Display shows 0 ZONES
- PROBLEM: Controller does not turn on zone when expected
-
-
-
- PROBLEM: Controller won't allow to SMART and/or no antenna icon on display
- PROBLEM: No Display
- PROBLEM: FAULT icon on display
- PROBLEM: Display shows zone is running but no sprinklers are operating
- PROBLEM: Controller keeps repeating a watering cycle
- PROBLEM: Display shows 0 ZONES
- PROBLEM: Controller does not turn on zone when expected
-
-
-
-
SmartLink
-
Other Products
-
-
-
-
- EM-7 Installation & Service Manual
- RM Series Service Manual
- RM Series Installation & Operating Instructions
- SSR10 Service Instructions
- SSR10 Owner's Manual
- Mark Series Wiring Diagram
- Mark Six and Mark Eight Operation Manual
- Mark A & Mark 200 Series Operating Manual
- 954 Charger Module Installation Instructions
- LM & LMC Operating Manual
- Weathermate Operating Manual (Espanol)
- Weathermate Operating Manual
-
-
DI6735T Series Installation Guide
Print
REPLACES: TORO® 630, 660, 730, 760
STEP 1: Remove Drive Assembly
STEP 2: Install New Nozzle
- Remove screws (2) on top of nozzle cap.
- Pull off nozzle cap.
- Snap in correct nozzle. (see Performance Chart)
- To remove nozzle, pull out using snap ring tool or screwdriver.
STEP 3: Install New Conversion Drive Assembly
- Place new assembly in body.
- Install new snap ring.
- Reinstall cap with screws (2).
Adjustable Part Circle Operation
- Rotor must be OFF.
- Rotate EASY ARC.
- Using a small screw driver or pointed object, move right and left tabs on each side of the Nozzle Marker. Example 180˚
- Install EASY ARC cap.
NOTE: Make sure nozzle faces area to be irrigated.
🔗 Performance Data
Table of Contents
