-
General Info
-
Controllers
-
-
-
- PROBLEM: Controller won't allow to SMART and/or no antenna icon on display
- PROBLEM: No Display
- PROBLEM: FAULT icon on display
- PROBLEM: Display shows zone is running but no sprinklers are operating
- PROBLEM: Controller keeps repeating a watering cycle
- PROBLEM: Display shows 0 ZONES
- PROBLEM: Controller does not turn on zone when expected
-
-
-
- PROBLEM: Controller won't allow to SMART and/or no antenna icon on display
- PROBLEM: No Display
- PROBLEM: FAULT icon on display
- PROBLEM: Display shows zone is running but no sprinklers are operating
- PROBLEM: Controller keeps repeating a watering cycle
- PROBLEM: Display shows 0 ZONES
- PROBLEM: Controller does not turn on zone when expected
-
-
-
-
SmartLink
-
Other Products
-
-
-
-
- EM-7 Installation & Service Manual
- RM Series Service Manual
- RM Series Installation & Operating Instructions
- SSR10 Service Instructions
- SSR10 Owner's Manual
- Mark Series Wiring Diagram
- Mark Six and Mark Eight Operation Manual
- Mark A & Mark 200 Series Operating Manual
- 954 Charger Module Installation Instructions
- LM & LMC Operating Manual
- Weathermate Operating Manual (Espanol)
- Weathermate Operating Manual
-
-
SLFA Flow Assembly Installation Instructions
Print
Items needed for assembly:
- Items included with each flow assembly
- 2 bolt kits with 2 bolts and 2 nuts
- Items not included:
- Teflon tape
- Primer rated for Schedule 80 PVC (IPS Weld-On p-70 or equal)
- Glue rated for Schedule 80 PVC (IPS Weld-On Gray 711, 705 or equal)
Notes
- Use teflon tape on male adapter threads.
- Must use primer on all joints prior to glue.
Tags:
Table of Contents
