< All Topics
Print

SLFSI-TXX Flow Sensor Technical Specifications

SLFSI-TXX Flow Sensor Technical Specifications
FileAction
Technical Specs – SLFSI-TXX Flow Sensor.pdfDownload

 FEATURES

  •  Molded Mounting Tee for improved control of dimensions for more consistent measurement and improved performance at low flow.
  •  Threaded Retaining Nut instead of retaining pin makes it easier to service in a valve box, more moisture resistance for electronics resulting in longer life.
  •  Unique 4 bladed lightweight impeller measures lower flow rates. Detects flow as low as 20% of published minimum rate of other impeller sensors
  •  Smart electronics detection system contains a micro-processor for better signal filtering and conditioning. Detection circuit also contains superior over-voltage and overcurrent protection.

Professional Materials

  •  Impeller – HDPE (High Density Polyethylene
  •  Shaft – Tungsten Carbide
  •  O-ring — Buna-N
  •  Saddle, Sensor Housing, Retaining Nut — Type 1 PVC

Pressure Rating

  •  150 PSI @ 90 degrees F

Temperature Range

  •  32 degrees F to 140 degrees F (0 degrees to 60 degrees C)

Output Signal

  •  Frequency Range: 0.3 Hz to 200 Hz
  •  Output Pulse: 5 ms +/-25%

Transducer Performance

  •  Quiescent current: 600 uA@8 VDC to 35 VDC max.
  •  Quiescent voltage: (VHigh) = Supply Voltage – (600uA X Supply Impedance)
  •  On State: (VLow) = Max. 1.2 VDC@50mA current limit, (10Ω +0.7VDC)

Flow Range

  •  0.25 to 15 FPS
  •  1 inch tee: 0.86 to 52 GPM
  •  1 1/2 inch tee: 1.8 to 108 GPM
  •  2 inch tee: 2.8 to 170 GPM

Electrical Cable

  •  2 single conductor solid copper U.L. listed #18 AWG leads with direct burial insulation
  •  Lead length: 48 inches
  •  Wiring may be extended up to 2,000 feet with direct burial, twisted pair shielded cable
Go to Top