SmartLink by Weathermatic   |    Catalogs    |    Support

CATALOGS   |   SUPPORT SmartLink by Weathermatic

Silver Bullet Technical Specification

Table of Contents
Technical Specs – Silver Bullet Series.pdfDownload


  • 5-year warranty and 100% water tested
  • 150 psi (10,3 bar) rating
  • Unique “reverse flow” porting design permits equal pressure distribution on both sides of the diaphragm, regardless of line pressure providing zero stress to prevent “stretching,” a common cause of valve failure
  • Pressure activated diaphragm
  • Normally closed valve for water conservation
  • Diaphragm’s self-cleaning ports constantly flex, inhibiting sand and silt from blocking valve action
  • Molded shock cone for smooth operation and reduction of water hammer
  • Easy-to-use internal manual bleed lever; bleeds valve downstream; has stops for open and closed positions
  • High efficiency S20P solenoid with stainless steel actuator
  • High-strength glass-filled body and cover with 1/4 in. stainless steel cover bolts and mating brass body inserts
  • Non-rising flow control stem throttles valve from full open to closed position on flow control models


  • Wiring requires a single lead from the controller to each solenoid, plus a common neutral to all solenoids; type UF wire, U.L. listed, is recommended for all hookups
  • 24VAC/60 Hz 24VAC/50 Hz
  • Inrush: 9.48 VA Inrush: 10.66 VA
  • Holding: 5.11 VA Holding: 5.99 VA
Go to Top