< All Topics
Print

Nitro Smart Control Zone Technical Specification

Nitro Smart Control Zone Technical Specification
FileAction
Technical Specs – SCZ-N-100F-H.pdfDownload 

FEATURES

1” Nitro Valve (N-100F-H)

  • 2-year warranty and 100% water tested
  • 150 psi (10,3 bar) rating
  • S20P high-efficiency solenoid for positive opening at high pressures. Stainless steel actuator and nylon threads
  • Unique “reverse flow” porting design permits equal pressure distribution on both sides of the diaphragm, regardless of line pressure providing zero stress to prevent “stretching,” a common cause of valve failure
  • Diaphragm’s self-cleaning ports constantly flex, inhibiting sand and silt from blocking valve action
  • Molded shock cone for smooth operation and reduction of water hammer
  • Easy-to-use internal manual bleed lever; bleeds valve downstream; has stops for open and closed positions
  • Engineering grade PVC body and cover with combination hex, slot, and Phillips retaining screws.
  • Non-rising flow control stem throttles valve from full open to closed position

1” Wye-Filter Regulator

  • Constructed of heavy duty glass filled nylon which operates between 20-150 psi pressure rating
  • Pre-assembled with a 200 mesh stainless steel screen element – Manual flush cap allowing for filter element flush
  • Directional flow arrows molded into body
  • Nominal pressure regulation of 25 psi – (1.73 bar)

ELECTRICAL

  • Wiring requires a single lead from the controller to each solenoid, plus a common neutral to all solenoids; type UF wire, U.L. listed, is recommended for all hookups
  • 24VAC/60 Hz 24 VAC/50 Hz
  • Inrush: 9.86 VA Inrush: 10.66VA
  • Holding: 5.11 VA Holding: 5.97 VA
  • Do not use nominal voltage ratings listed above for sizing of valve wires

OPERATION

  • Flow: – 0.20 to 20.0 gpm
  • Filtration: 150 mesh stainless steel

DIMENSIONS

6 ½” H x 14 ¾” L x 3 ¼” W

MODEL

SCZ-N100F-H – 1” Nitro (N-100F-H) Valve; 1” Wye-Filter/Regulator (25 PSI)

Go to Top