SmartLink by Weathermatic   |    Catalogs    |    Support

CATALOGS   |   SUPPORT SmartLink by Weathermatic

Nitro Series Technical Specification

Table of Contents
FileAction
Technical Specs – N-100 Series.pdfDownload

FEATURES

  • 100% water tested
  • 150 psi (10,3 bar) rating
  • Unique “reverse flow” porting design permits equal pressure distribution on both sides of the diaphragm, regardless of line pressure providing zero stress to prevent “stretching,” a common cause of valve failure
  • Normally closed valve for water conservation
  • Diaphragm’s self cleaning ports constantly flex, inhibiting sand and silt from blocking valve action
  • Molded shock cone for smooth operation and reduction of water hammer
  • Easy-to-use internal manual bleed lever; bleeds valve down-stream; has stops for open and closed positions
  • High efficiency S20P solenoid with stainless steel actuator
  • Engineering grade PVC body and cover with combination hex, slot and Phillips retaining screws
  • Non-rising flow control stem throttles valve from full open to closed position on flow control models

ELECTRICAL

  • 24VAC/60 Hz
  • Inrush: 9.48 VA
  • Holding: 5.11 VA
  • 24VAC/50 Hz
  • Inrush: 10.66 VA
  • Holding: 5.97 VA

Do not use nominal voltage ratings listed above for sizing of valve wire.

Tags:
Go to Top