Bronze Bullet Technical Specification

FEATURES

• 100% water tested
• 150 psi (10,3 bar) rating
• Unique “reverse flow” porting design permits equal pressure distribution on both sides of the diaphragm, regardless of line pressure providing zero stress to prevent “stretching,” a common cause of valve failure
• Normally closed valve for water conservation
• Diaphragm’s self cleaning ports constantly flex, inhibiting sand and silt from blocking valve action
• Molded shock cone for smooth operation and reduction of water hammer
• Easy-to-use internal manual bleed lever; bleeds valve down-stream; has stops for open and closed positions
• High efficiency S20P solenoid with stainless steel actuator
• Engineering grade PVC body and cover with combination hex, slot and Phillips retaining screws
• Non-rising flow control stem throttles valve from full open to closed position on flow control models

ELECTRICAL

• 24VAC/60 Hz
• Inrush: 9.48 VA
• Holding: 5.11 VA

• 24VAC/50 Hz
• Inrush: 10.66 VA
• Holding: 5.97 VA

Do not use nominal voltage ratings listed above for sizing of valve wire.