SmartLink by Weathermatic   |    Catalogs    |    Support

CATALOGS   |   SUPPORT SmartLink by Weathermatic

Silver Bullet Smart Control Zone Technical Specification

Table of Contents
Technical Specs – SCZ-SB-10F.pdfDownload


1” Silver Bullet Valve (SB-10F)

  • 2-year warranty and 100% water tested
  • 150 psi (10, 3 bar) rating
  • S20P high-efficiency solenoid for positive opening at high pressures. Stainless steel actuator and nylon threads
  • Unique “reverse flow” porting design permits equal pressure distribution on both sides of the diaphragm, regardless of line pressure providing zero stress to prevent “stretching,” a common cause of valve failure
  • Diaphragm’s self-cleaning ports constantly flex, inhibiting sand and silt from blocking valve action
  • Molded shock cone for smooth operation and reduction of water hammer
  • Easy-to-use internal manual bleed lever; bleeds valve downstream; has stops for open and closed positions
  • High-strength glass-filled body and cover with ¼ in. stainless steel cover bolts and mating brass body inserts
  • Non-rising flow control stem throttles valve from full open to closed position

1” Wye-Filter Regulator

  • Constructed of heavy duty glass filled nylon which operates between 20-150 psi pressure rating
  • Pre-assembled with a 200 mesh stainless steel screen element – Manual flush cap allowing for filter element flush
  • Directional flow arrows molded into body
  • Nominal pressure regulation of 25 psi – (1.73 bar)


Wiring requires a single lead from the controller to each solenoid, plus a common neutral to all solenoids; type UF wire, U.L. listed, is recommended for all hookups

  • 24VAC/60 Hz 24 VAC/50 Hz
  • Inrush: 9.48 VA Inrush: 10.66 VA
  • Holding: 5.11 VA Holding: 5.99 VA
  • Do not use nominal voltage ratings listed above for sizing of valve wires


  • Flow: – 0.20 to 20.0 gpm
  • Filtration: 150 mesh stainless steel


6 ½” H x 15” L x 3” W


SCZ-SB-10F – 1” Silver Bullet (12024E-10F) Valve; 1” Wye-Filter/Regulator (25 PSI)

Go to Top