File	Action
Technical Specs – 11000 Series.pdf	Download

FEATURES

• 10 year warranty and 100% water tested
• 225 psi (15,5 bar) rating
• S24B high-efficiency solenoid for positive opening at high pressures. Stainless steel actuator and brass threads
• Unique “reverse flow” porting design permits equal pressure distribution on both sides of the diaphragm, regardless of line pressure providing zero stress to prevent “stretching,” a common cause of valve failure
• Normally closed valve for water conservation
• Diaphragm’s self cleaning ports constantly flex, inhibiting sand and silt from blocking valve action
• Brass shock cone for smooth operation and reduction of water hammer
• Easy-to-use internal manual bleed lever; bleeds valve downstream; has stops for open and closed positions
• High-strength glass-filled body and cover with 1⁄4 in. stainless steel cover bolts and mating brass body inserts
• Brass non-rising flow control stem throttles valve from full open to closed position
• Excellent for micro-irrigation
• Contamination resistant (CR)
• Chloramine resistant diaphragm

ELECTRICAL

Wiring requires a single lead from the controller to each solenoid, plus a common neutral to all solenoids; type UF wire, U.L. listed, is recommended for all hookups

• 24VAC/60 Hz 24 VAC/50 Hz
• Inrush: 9.86 VA Inrush: 10.7 VA
• Holding: 5.69 VA Holding: 7.5 VA

               Do not use nominal voltage ratings listed above for sizing of valve wires

INSTALLATION

•                Teflon tape is recommended
•                1 in. FIP can be bushed to 3⁄4 in.
•                1 1⁄2 in. FIP can be bushed to 1 1⁄4 in.

               *International threads (specify ISO)